Two-Component Polyurethane Adhesive

Use

Two-component polyurethane adhesive for rubber flooring , PVC flooring, cork flooring, linoleum , flooring and outdoor sports ground and artificial turf and so on.

Suitable in dry subfloor , such as: the use of cement mortar subfloor , concrete , wood, plywood, ceramic tile , stone, metal and other basic . Particularly suitable for use in high- load floor.

Notes

Comply with manufacturer's regulations. It contains isocyanates. Harmful by inhalation. Irritating to eyes, respiratory system and skin. May cause allergic reaction by inhalation or in contact with skin. In case of contact with eyes, rinse immediately with plenty of water and seek medical advice. Remove contaminated clothing immediately. In contact with skin, wash immediately with plenty of water and soap. Wear protective gloves and eye/face protection. In case of accidents or users feel unwell, seek medical advice immediately.

Packaging and Storage

Component A 10kg, component B 2kg. This product can be stored in original packaging for 12 months. Store in a cool, dry environment. Low temperature storage results in increased viscosity, so it should be kept indoors to room temperature (at least 15℃) before use.

<div

Substrate Treatment

The surface must be firm, smooth, dry, clean and free of cracks. If a flat base surface , use a self-leveling refined beauty of self-leveling compound . When used directly without leveling absorbent subfloor , please seal the base with M190 Epoxy Reinforcement and Moisture-proof Primer. Dense, smooth sanding required basis . Please comply with the relevant product specifications .

Construction Method

Before use, please open the large bucket (10kg), and then pour the components in the small bucket (2kg) into the large bucket, must use a suitable electric mixer to stir the product fully. Pour the thoroughly stirred mixture into another clean container and stir slightly again. Make sure you mix thoroughly, evenly and have the same color. Pay special attention to the walls and bottom of the container when mixing. Use a scraper to evenly spread the product to the base surface (see "consumption chart"). Lay the floor and roll it evenly. Roll the floor again after 2-3 hours. Make sure the glue is fully transferred to the back of the floor. After construction, the tools can be cleaned immediately with ethyl acetate and other additives.