LVT Flooring Adhesive

Uses

High efficiency water - based adhesive, suitable for adhesion of all kinds of LVT and PVC flooring.

Features

High peel strength, high peel strength

High shear strength, can resist shear deformation and floor shrinkage

Green and Environmental Protection

Applicable Subfloor

Suitable for porous absorbent , strong, smooth, dry, clean , no cracks , no grease, no wax floors

Applies to the hard cement-based self-leveling screed

For aerial wood flooring , plywood and particleboard cushion .

Primary Treatment

Substrate if has oil contamination, wax water and mold release, required wax water decontamination to treatment; recommend M318 Water-Based Primer or M139 for closed minor sand ground (porous absorbent subfloor); recommend Self-Leveling Polymer Cement for leveling uneven ground(leveling thickness at least 2mm); recommend M190 Epoxy Reinforcement and Moisture-proof Primer for treatment wet subfloor moisture. The subfloor presence of cracks recommend M190 Epoxy Reinforcement and Moisture-proof Primer or M220 Rapid Repair Mortar to repair.

Notes

If the ambient temperature is lower than 15 ℃ or the relative humidity is higher than 75%, contact our technical personnel for advice. If there is a film on the surface of the adhesive after opening, it should be removed and stirred evenly before use. Do not dump the adhesive into the ditch or sewer, after the completion of construction should be the unused adhesive barrel cover sealed storage, short-term storage (not more than 10 days) can be used twice.

Packaging and Storage

25kg or 5kg plastic pails. The product shall be kept at room 5 ℃ -35 ℃, prevent freezing, exposure. Shelf life of 12 months.

<div

Construction Method

Without dilution , without the need to deploy , with A2 or A3 sheet tooth scraping the glue evenly over the surface coated in construction . If the surface of the open barrel found a small amount of clear liquid , stir and then need to glue construction. According to the construction site of the temperature and humidity , wait about 10-20 minutes after (sticky hands drawing a clear sense of touch) can spread the glue on the surface of the floor , and then push the plate with cork flooring flatten , then 50 kg pressure roller rolling on the paved floor , can achieve better results.